Preformed-Particle-Gel Transport through Open Fractures and its Effect on Water Flow
This work constructed transparent fracture models to visually track swollen preformed-particle-gel (PPG) propagation through open fractures and water flow through PPG placed in the fractures. During injection, PPG propagated like a piston along a fracture and a gel pack was formed in the fracture. When water broke through the particle-gel pack after PPG placement, several channels were created that discharged water from the outlet while water was being injected. Investigation of factors that influence PPG injectivity and plugging efficiency revealed that PPG injectivity increases with fracture widths and flow rates but decreases with brine concentrations (on which the PPG swelling ratio depends). PPG can reduce the permeability for the fractures with different widths to the same level. Full-factorial experimental design analysis was performed to rank the influence of injection rate, fracture width, and PPG swelling ratio on pressure response, resistance factors, and injectivity.
H. Zhang and B. Bai, "Preformed-Particle-Gel Transport through Open Fractures and its Effect on Water Flow," SPE Journal, vol. 16, no. 2, pp. 388-400, Society of Petroleum Engineers (SPE), Jun 2011.
The definitive version is available at https://doi.org/10.2118/129908-PA
Geosciences and Geological and Petroleum Engineering
Keywords and Phrases
Brine Concentration; Discharged Water; Fracture Model; Fracture Width; Injection Rates; Injectivity; Pressure Response; Resistance Factors; Swelling Ratio; Water Flows; Flow Of Water; Gels; Hydraulics; Fracture
International Standard Serial Number (ISSN)
Article - Journal
© 2011 Society of Petroleum Engineers (SPE), All rights reserved.
01 Jun 2011