The effects of downstream base-level control on fluvial architecture and geometry are well explored in several broadly similar sequence-stratigraphic models. Cretaceous Dakota Group strata, U.S. Western Interior, have characteristics reflecting combined downstream and upstream base-level controls that these models cannot address. Particularly, three layers of amalgamated channel-belt sandstone within this group thicken and are continuous for distances (≤ 300 km) along dip that stretch the reasonable lengths for which these models are intended to apply. As well, architecture in up-dip reaches records repeated valley-scale cut-and-fill cycles. This contrasts with equivalent strata down dip which record channel-scale lateral migration with no such valley-scale cycles apparent. We here introduce the concept of "buffers and buttresses" to address these observations. We assume that river longitudinal profiles are each anchored down dip to some physical barrier (e.g., the sea strand, etc.) that we refer to as a "buttress." Buttress shift is considered the primary downstream control on base level. Profiles extrapolated up dip from the buttress over any modeled duration of buttress shift can range widely because of high-frequency variability in upstream base-level controls (e.g., discharge, etc.). All these potential profiles however are bounded above by the profile of highest possible aggradation, and below by the profile of maximum possible incision. These upper and lower profiles are "buffers," and they envelop the available fluvial preservation space. Thickness of the buffer zone is determined by variability in upstream controls and should increase up dip to the limit of downstream profile dominance. Dakota valley-scale surfaces record repeated cut-and-fill cycles driven by up-dip controls and are confined between thick stable buffers. Equivalent strata down dip record lateral reworking within a thinner channel-scale buffer zone that was positioned by downstream controls. Regression exposed slopes similar to the buffer zone, thus buffers were stable for long distances and durations. This prompted dip-extensive lateral reworking of strata into upstream valley-scale and downstream channel-scale sheets. Buffers and buttresses provide a broadly applicable model for fluvial preservation that captures upstream vs. downstream base-level controls on geometry and architecture. The model lends general insights into dip-oriented variations in fluvial architecture, production of sheet vs. lens geometry, total preservation volumes for fluvial systems, and variations in these factors related to contrasting climatic conditions and basin physiography. The model can be amended to existing sequence stratigraphic approaches in order to capture dip-oriented variations in sequence architecture.
J. M. Holbrook et al., "Base-Level Buffers and Buttresses: A Model for Upstream versus Downstream Control on Fluvial Geometry and Architecture within Sequences," Journal of Sedimentary Research, vol. 76, no. 1-2, pp. 162-174, SEPM Society for Sedimentary Geology, Jan 2006.
The definitive version is available at http://dx.doi.org/10.2110/jsr.2005.10
Geosciences and Geological and Petroleum Engineering
Keywords and Phrases
Fluvial Process; Sedimentary Structure; Sequence Stratigraphy
International Standard Serial Number (ISSN)
Article - Journal
© 2006 SEPM Society for Sedimentary Geology, All rights reserved.